例句與造句

1. Correlations of aqueous solubility of amino acids by a modified regular solution model
   應用改進的正規溶液模型關聯氨基酸在水中的溶解度
2. So the fitting effect of mivm is better than that of the regular solution model in binary solid alloys
   分子相互作用體積模型在二元固態合金中的活度擬合效果優于正規溶液模型。
3. As to the weak deviation systems , they are fitted well with wilson equation and regular solution model
   對于弱偏差體系，兩者的擬合效果都較好。相對來說， wilson方程要優于正規溶液模型。
4. Relatively , wilson equation fits better than regular solution model , but the symmetrical systems are fitted better with regular solution model
   對于其中的對稱體系，則正規溶液模型的擬合效果更佳。
5. But it is not for the regular solution model , because the influence of temperature has been taken into account when the parameters are calculated
   正規溶液模型在計算二元系參數時已經考慮了溫度的影響，則未發現此類現象。
6. It's difficult to find regular solution in a sentence. 用regular solution造句挺難的
7. The results also indicate that the suitability of wilson equation and regular solution model to multi - component systems is restricted by the binary systems and temperature
   預測結果表明，對多元系熱力學性質的預測受二元系的影響較大。
8. In this thesis , the thermodynamic properties of 24 binary al - based liquid alloys are then fitted with wilson equation and the regular solution model
   隨后利用wilson方程和正規溶液模型對24個二元鋁基液態合金體系的熱力學性質進行了擬合。
9. The molecular interaction volume model ( mivm ) and the regular solution model have been applied to fit the activities of components in 37 binary solid alloys
   摘要應用分子相互作用體積模型和正規溶液模型對37個二元固態合金體系的組元活度進行了擬合。
10. The results also show that wilson equation and regular solution model are not suitable for the systems that had immiscible gaps in the liquid phases
    對于存在液-液分層現象的體系， wilson方程和正規溶液模型的擬合效果都較差，都不適合于這類體系的熱力學性質計算。
11. This paper considers a general linear elliptic complex equation of first order in the plane , and proves that the weakly regular solutions must be the regular ones under condition c
    摘要考慮復平面上一般一階線性橢圓型復方程，在條件c下，證明?其弱正則解必為正則解。
12. The results show that wilson equation and the regular solution model are suitable for the strong positive deviation systems , but not for the strong negative and coexisted deviation ones
    結果表明： wilson方程和正規溶液模型對強正偏差體系比較適合，不適用于強負偏差體系和混合偏差體系。
13. The comparison of application of wilson equation and regular solution model in the al - based liquid alloys shows that the suitability of regular solution model is restricted because it is only fit for the systems in which the components has the approximate size and structure
    Wilson方程和正規溶液模型在二元及多元鋁基液態合金體系中的比較研究表明：正規溶液模型因?yàn)樵瓌t上只適用于組元的分子大小和結構相近的體系，其適用范圍受到了限制。
14. For the interface problems with variable coefficients , it is introduced that a particular finite element method combined with the infinite element method to approach the singular solution in the neighborhood of the singular points , and it is proved that the method possesses the same accuracy as the finite element method to the regular solution
    對變系數內邊界問題，介紹了一種特殊的有限元方法。該方法結合了無限元方法，使在奇點附近的奇性解得到好的逼近。證明了該方法具有與有限元方法對正則解相同的精確度。